gapping fault是什么意思

网络释义

用法例句

The boundary integral method is applied to the analysis of opening displacement and stress intensity factor of surface crack.

用边界积分方法,分析表面裂纹的张开位移和应力强度因子。

Under the ratios of various initial cracking relative length,height and volume of gas concrete beam,the whole curve of opening displacements at several testing points about fracture toughness,fracture energy,and in the area of load,cracking-tip-opening-displacement,cracking tip opening displacement cracking-tip-area are researched systematically.

在本研究中对加气混凝土梁在不同初始裂纹相对长度、不同高度以及不同体积比例等情况下的断裂韧性、断裂能以及载荷—裂纹口张开位移—裂纹尖端张开位移—裂纹尖端前沿区若干测点张开位移全曲线进行了系统研究。

The fracture energy,the crack mouth opening displacement and the crack tip opening displacement of the specimens were also measured.

为了研究聚丙烯纤维对水泥稳定碎石断裂韧性的影响,通过聚丙烯纤维水泥稳定碎石和普通水泥稳定碎石的三点弯曲试件断裂试验,测得了试件的断裂能、裂缝嘴张开位移和裂缝尖端张开位移,给出了聚丙烯纤维体积掺量的合理范围——0。

Engineering solution of crack tip opening displacement for surface plate subjected to uniformly distributed forces with center through crack is derived.

首先对ＥＰＲＩ方法建立的裂纹中心板张开位移的工程解进行了实例计算，然后用有限元法对平板中心穿透裂纹张开位移计算得到的有限元解与其进行了比较，得出工程解偏于保守的结

The SPI technique was used to measure in situ the crack tip strain and crack opening displacement(COD) at various loading stages in one loading cycle during constant amplitude fatigue crack propagation.

应用散斑干涉技术，在常幅载荷下对疲劳裂纹扩展过程中的一个循环周期内，不同加载阶段的裂尖应变、裂纹张开位移进行了原位测量，给出了裂纹闭合对裂纹张开位移及裂尖形变的影响规律。

The relationship between fictitious crack length and stress intensity factor or crack opening displacement is also given.

基于虚裂纹模型的概念 ,导出了无限大板中心直裂纹在远场均匀拉应力作用下双参数模型的应力函数和位移函数 ,其解由线弹性断裂力学解、Dudale的解答和加权积分法导出的虚裂纹模型解所构成 ,最后给出了虚裂纹长度与应力强度因子及张开位移的关

In this paper, a method is proposed to estimate the plastic zone size, by extending the Dugdale model to three dimensional (3D) crack problems and the crack opening displacement (COD) at the tip of a sptatial penny shaped crack by combining the Barenblatt Dugdale model with the principle of 3D J integral, then the relationship between J integral and COD is obtained.

将Ｄｕｇｄａｌｅ模型推广到三维裂纹问题计算了圆盘状裂纹前缘塑性区尺寸，并结合断裂力学中的Ｂａｒｅｎｂｌａｔ－Ｄｕｇｄａｌｅ裂纹模型和三维Ｊ－积分原理计算了圆盘状裂纹前缘张开位移，得到了Ｊ－积分与裂纹张开位移的关系。

The faults can be divided into two categories:the open type and the closed type.

根据断层性质，断层可以划分为张开型断层和闭合型断层。

It was found that the opening angle and residual strains of the asthma rat trachea cut at the cartilaginous region was significantly larger than those of the normal rat.

与正常组相比,模型大鼠气管软骨剪开的张开角及所对应的残余应变绝对值均较正常组显著增大(P<0。

Results in this paper show that for the no-load ring of rat trachea, the opening angle obtained for cartilaginous cut differs from that for muscular cut, i.

文章结果表明，对于大鼠无载荷状态气管环，软骨剪开与肌肉剪开所展成的张开角是不同的，软骨剪开对应的张开角明显大于肌肉剪开的张开角。

The former was trained on treadmill in the light of Bedford rat endurance training model,and 16 weeks later,the rats were decapitated and their thoracic aortas were taken out and used to test the opening angle,wall thickness(WT), internal diameter(ID)and the ratio of WT and ID with a computer picture collection and analysis system.

将SD大鼠随机分成训练组和对照组,参照Bedford大鼠耐力训练模型对训练组进行电动跑台训练,16周后将SD大鼠断头处死,将胸主动脉取出,使用计算机图像采集及分析系统测量血管环的张开角、壁厚、内径并计算壁厚/内径。