Test and analysis of intergranular corrosion for stainless steel surfacing strip;
不锈钢焊带晶间腐蚀试验分析
Influence of quench rate and zirconium content on intergranular corrosion of 7055 type aluminum alloy;
淬火速率和锆含量对7055型铝合金晶间腐蚀的影响
Effevt of V on intergranular corrosion resistance of austenite weld metal;
元素V对奥氏体焊缝金属晶间腐蚀敏感性的影响
Effects of aging treatment on intercrystalline corrosion and exfoliation corrosion behavior of 7A52 aluminum alloy;
时效工艺对7A52铝合金晶间腐蚀和剥蚀行为的影响
Study of Anti-intercrystalline corrosion performance for welded joint of stainless steel sheet used for urban rail passenger car;
城轨车用不锈钢薄板焊接接头抗晶间腐蚀性能的试验研究
The microstructure after heat treatment was observed,the content of ferrite was measured(<40%),and the hardness measurement,pitting corrosion and intercrystalline corrosion test were also conducted.
对热处理后的组织进行了金相观察,测定铁素体体积百分含量低于40%,并进行硬度测量、点腐蚀以及晶间腐蚀试验。
The sensitization to intergranular attack(IGA) of Fe-17Mn-13Cr-0.
3N奥氏体不锈钢的耐晶间腐蚀的程度。
The susceptibility to intergranular attack(IGA) of austenitic stainless steel were studied by electrochemical potentiokinetic reactivation(EPR).
利用电化学动电位再活化(即EPR)法检测了奥氏体不锈钢晶间腐蚀敏感性的程度。
is the working temperature of the sodium loop, the intergranular attack property of the materials should be considered in structure material selection.
研究表明:316不锈钢在此环境下,由于敏化所造成的晶间腐蚀不可避免,而316Ti和316L不锈钢的抗晶间腐蚀性能优于316不锈钢。
intergranular corrosion test for aluminium alloy
铝合金晶间腐蚀试验
Nickel-based alloys--Determination of resistance to intergranular corrosion
GB/T15260-1994镍基合金晶间腐蚀试验方法
The method for determining the intergranular corrosion of aluminium alloy
GB/T7998-1987铝合金晶间腐蚀测定方法
Study on Intergranular Corrosion Micrographics of 5083/5086 Alloy Plates
5083/5086合金板材晶间腐蚀特征图谱研究
Optimization Research of Inter-crystalline Corrosion-resistant Process for 316 Stainless Steels
316不锈钢抗晶间腐蚀工艺优化的研究
Intergranular Corrosion Cause Analysis of Incoloy825
Incoloy825合金晶间腐蚀原因分析
The Research on the Intergranular Corrosion of 316 Stainless Steel
316不锈钢的晶间腐蚀行为的研究
Effect of Microstructure to Corrosion Properties for Welded Joint of P91+SUS347 Steel
P91+TP347H焊接异质接头晶间腐蚀研究
Research on the SCC and IGC Performance of Welded Joints of A7N01S Aluminum Alloy;
A7N01S铝合金焊接接头应力腐蚀及晶间腐蚀行为的研究
The non-sensitized IGC of austenitic SS may be lightened by using high purity SS.
使用高纯不锈钢可以减轻非敏化态晶间腐蚀。
18-8 Austenite stainless steel joint measurements about Intercrystalline Corrosion;
18-8奥氏体不锈钢接头晶间腐蚀的控制
Failure Reason for the Nickel-based Alloy Weld Intergranular Corrosion Test
镍基合金焊缝晶间腐蚀试验不合格原因浅析
Effect of Manufacture Parameters on Intergranular Corrosion Properties of 1Cr18Ni9Ti Pipe
制管工艺对1Cr18Ni9Ti航空管晶间腐蚀性能的影响
Intergranular Corrosion Susceptibility of Welded Joint of Stainless Steels
不锈钢热轧板材焊接接头的晶间腐蚀试验
Effect of Quenching Agent on Intergranular Corrosion Resistance of High-strength Aluminum Alloy
淬火介质对高强铝合金晶间腐蚀性能的影响
Experiment and Analysis for Welded Joint Anti-Intercrystalline Corrosion of 0cr18ni9 Steel
提高0Cr18Ni9钢焊缝抗晶间腐蚀性的试验及分析
A Study on Intergranular Corrosion Resistance and Grain Boundary Character Distributions of Cold Rolled and Annealed 316L Stainless Steels;
冷轧退火316L不锈钢的晶间腐蚀性能及晶界特征分布研究
Effect of Pre-Deformation on Aging Behavior and Intergranular Corrosion Property of SUPER304H Stainless Steel;
预变形对SUPER304H不锈钢时效行为及晶间腐蚀性能的影响
CopyRight © 2020-2024 优校网[www.youxiaow.com]版权所有 All Rights Reserved. ICP备案号:浙ICP备2024058711号