injector-producer distance是什么意思

网络释义

用法例句

Therefore,the producer-injector spacing corresponding to the minimum displacement pressure gradient overcoming the starting pressure gradient of low permeability reservoir is just the maximum spacing for establishing effective displacement between injector and producer.

启动压力规律和渗流理论研究表明,只有当驱替压力梯度完全克服油层启动压力梯度时,注采关系才能建立,因此克服低渗透油层启动压力梯度的最小驱替压力梯度所对应的注采井距,即是注水井和生产井之间能够建立有效驱替的最大注采井距。

Investigations have been made of reasonable well spacing density, producer-injector spacing and water-injecting mode, which.

针对注水开发油田经过二次加密调整且开采一段时间后,剩余油分布具有平面上不均衡、纵向上高度分散难采度加大的特点,研究了合理井网密度、注采井距、注水方式,结果表明:大庆萨北油田北三区东部三次加密调整预测可调砂岩厚度为12。

To ultra-low permeability reservoir,the key point of development effectiveness is producer-injector spacing,at the present,it is determined by means of permeability and threshold pressure gradient(TPG).

注采井距是影响特低渗透油藏开发效果的关键,目前主要根据渗透率和启动压力梯度大小来确定。

Calculating the limit injector-producer distance in low permeability pool by with start-up pressure gradient

利用启动压力梯度计算低渗油藏极限注采井距

Based on the example in Min114 block at Xinmin oil field,the authors analyze the relation of the fracture and crustal stress,measure the direction and length of the hydraulic fracture by receiving the microseism signals when the terrene is broken,which provides a basis for deploying reasonable flood pattern for development of low permeability reservoir.

以新民油田民114区块为实例,利用微震裂缝监测技术,通过接收地层破裂时的微震信号测定水力压裂产生的人工裂缝的走向与长度,分析裂缝发育与地应力的关系,为低渗透油藏开发中合理部署注采井网提供依据。

The study on injection-production well distance and injection effective time in Shiwu Oilfield

十屋油田注采井距与注水见效时间研究

Calculating the limit injector-producer distance in low permeability pool by with start-up pressure gradient

利用启动压力梯度计算低渗油藏极限注采井距

With a vaporizing gas drive, miscibility is achieved at some distance from the injection well.

在蒸汽驱中，混相在距注井一定距离出现。

Development of valve device for injection-production integrated technology of heavy oil thermal recovery slim holes

稠油热采井注采一体化配套开关装置

INFLUENCE OF STEAM INJECTION PARAMETERS ON WELL-BORE TEMPERATURE

热采井注汽工艺参数对井筒温度的影响

The study of accommodation of injection-production pattern for Chang6_2 Reservoir, ST2 borefield,Zhenjing oilfield

镇泾油田ST2井区长6_2油藏注采井网适应性研究

Optimized Analysis on Boundary Distance of Mine with Surface and Underground Combined Mining

露天与井工联合采动矿山边界距离优化分析

Effects of Well Pair Distance on Pumping Temperature of Storage Exploiting in the Aquifer of Water-source Heat Pump

井对间距对含水层采能区抽水温度的影响

Analysis on the Selection of Re-Injection of Salt Making Waste Water Into Rock Brine Well Mining Area

制盐废水回注岩盐卤井采区选择分析

Perforations for Steam Flood Injecion-production Thick Oil Wells in Liaohe Oilfield

辽河油田稠油蒸汽驱注采井射孔方式

Determination of Reasonable Horizontal Distance Between Open-Off-Cut and Slope Under the Combined Mining Mode of Open-Pit with Underground Mining

井工-露天联采模式下井工开切眼与边坡合理距离的研究

Gas-injection production technology using underground gas-storage salt cavern to displace brine solution and contain injected gas

地下盐穴储气库注气排卤及注采完井技术

Reinforced Technology of Xinliu Coal Mine Auxiliary Inclined Shaft for Coal Mining Face Short Distance Crossing Over Inclined Shaft

新柳煤矿回采工作面近距离跨采副斜井加固技术

Slope Shaft Construction Method by Grouting with Advanced Pipe through Aeolian Sand Seam

采用超前导管注浆法过风积沙层的斜井井筒施工方法

The Research about the Factors Affecting Formation Rock and Casing by Well-Completion and Injection-Production Technique;

完井、注采工艺对地层岩石及套管影响因素研究

Casing Strength Theoretical and Experimental Study of Thermal Recovery Steam Injection Wells;

注蒸汽热采井套管强度理论与试验研究

Research on Well Pattern Optimization for Xinhuan-27 Faulted-block of Liaohe Oilfield

辽河油田新欢27断块注采井网优化研究

A Method for Evaluation of EOR of Waterflooding Oilfield by Infill Well Process

加密井提高注水开发油田采收率的评价方法