left-hand joint是什么意思

网络释义

用法例句

Although the designing of main structure can be solved by criterions of codes, the research in sheathing of the building is quite scare, especially in the fields of clip connection between the profiled steel sheets and members.

尤其是目前广泛应用的扣合式连接的屋面、墙面板，虽然已有大量的工程实例，但由于缺乏相关的设计依据，工程事故频有发生。

For the join operator that is the most difficult to process and optimize in DBMS,the query optimization strategies, based on genetic algorithms, over the plan collections of left-deep join tree and the plan collections of bushy join tree are discussed.

介绍基本遗传算法的基本思想和工作流程,针对数据库管理系统中最难处理和优化的连接操作,讨论在左深连接树的计划集合和浓密连接树的计划集合上的基于遗传算法的查询优化策略。

chain cable shackle

联接卸扣锚链连接卸扣

a fastener that serves to join or link.

用来连接或结合的扣件。

fasten or join with a joggle.

用啮合扣固定或连接。

CLAMPING FORCE ANALYSIS FOR ON/OFF SLIP OF CONTINUOUS-CIRCULATION SYSTEM

钻井连续循环系统上卸扣卡瓦卡紧力分析

Analysis on Elastic Load Bearing Capacity of Tubes Inside Slips

连续循环系统上卸扣卡瓦卡紧力计算方法研究

To join or attach by means of a joggle.

榫接，啮合用啮合扣或接榫连接或安装

Remove the cover plate of the relief valve by removing the four connecting screws.

通过拆卸四个连接螺丝来拆卸安全阀盖板。

Remove nut securing pedal shaft in support bracket.

拆卸支撑托架上连接踏板轴的螺帽。

The grounding wires can be fixed on case body and case door. The connecting parts can be detached.

箱体和箱门上都可安装接地线，连接件可以卸下。

Generic specification for installing and removal tools for connectors electrical contact

GB/T12793-1991电连接器接触件嵌卸工具总规范

tighten or fasten by means of screwing motions.

通过连接动作来使变紧或扣紧。

Loosen but do not fully remove the four bolts that attach the stabilizer bar bushing retainers to the rear axle brackets.

松开但不完全拆卸接合稳定杆衬套扣环与后车轴支架的4支螺栓。

Uninstalling a component removes it from all network connections. Are you sure you want to uninstall %1?

卸载一个组件会将其从所有网络连接上删除。确实要卸载 %1 吗?

Uninstalling a component removes it from all network connections. Are you sure you want to uninstall %1?\0

卸载一个组件会将其从所有网络连接上删除。确实要卸载 %1 吗?\0

When removing the connector, do not hold the harness, but hold the connector.

(2)在拆卸连接器时，不要握住线束，而应握住连接器。

To examine diaphragm, disassemble coupling nut (6) and lift off pressure plate (7).

检查隔膜，拆卸连接螺母(6)并提升压力板(7)。

Remove the relief valve hose from fitting below inlet ball valve.

从进口球阀下面连接件拆卸安全阀软管。

Remove valve spring and retainer.

拆卸阀弹簧和扣件。