gland retainer plate是什么意思

网络释义

用法例句

Through the investigation and analysis of steel connector installation at Xinghujie Station in Suzhou Subway, one way that will improve the installation quality, namely with locator card and cover board, is put forward.

在苏州地铁星湖街站的施工中,通过对接驳器施工的质量现状的调查和分析,提出了一种改进接驳器施工质量的方法——"定位卡"及"封盖板",现场试验的效果表明,改进工艺后克服了接驳器定位偏差和丝牙破坏、锈蚀等弊病。

Renewal and Transformation of Bearing Sealing Cover on Yantan Hydropower Co. Ltd.

岩滩发电公司机组轴承密封盖更新改造

The bottom bearing applies both labyrinth seal and frame seal, which have good performance of sealing. The main shaft is anticorrosive.

下轴承端盖密封采用双重密封，可确保密封效果，主轴采用防腐新技术，能保护主轴免受腐蚀。

Permanently sealed and lubricated ball bearings front and rear.

前后端盖装有永久密封和自润滑的滚珠轴承。

fully sealed & self-lubricated bearing

全密封自动润滑轴承

pressure balanced bearing seal

压力平衡式轴承密封

non-contact sealed ball bearing

非接触式密封球轴承

An Improved Design on Seal Groove and Seal Ring of Spherical Plain Bearing

关节轴承密封槽及密封圈的设计改进

Research on Assembly Reliability and Sealing Properties of the Bearing Sealed Ring;

轴承密封件安装稳定性与密封特性研究

Analysis of Seal Rings Nonlinear Distortion and Seal Capability of Bearing;

密封件非线性变形与轴承密封性能研究

Replacement inside the Tunnel and Failure Analysis of Sealing of TBM Main Bearing

TBM主轴承内密封洞内更换及失效分析

Numerical Simulation Study of Helical Seal on Water-lubricated Hydrostatic Bearings

水润滑轴承螺旋密封性能的仿真分析

In-the-hole Repair Technique for Main Shaft Lip Seal on TBM

TBM主轴承唇形密封洞内修复技术

Intunnel vestoration and airproof fault diagnosis in TBM main bearing

TBM主轴承内密封故障诊断与洞内修复

Sealed type bearings are mudproof, dustproof, and leakproof(grease) without the use of shaft seals.

密封型轴承具有防泥、防尘、防漏（脂）性能，无需使用轴密封。

Oil may be forced out through the timing cover and rear-main bearing oil seals.

机油会从正时齿轮盖和后主轴承油封处压出。

TEST STUDY OF A NEW TYPE NON-SEAL SLIDING BEARING CONE BIT

新型非密封滑动轴承牙轮钻头的试验研究

The dynamically balanced rotor assembly,sealed bearings with grease reserviors.

动平衡的转子总成，具有蓄油装置的全密封轴承。

Study on Modeling and Behaviors of Rotor-Bearing-Seal System Dynamics;

转子—轴承—密封系统动力学建模及其特性研究