Proteases in milk and gelation of UHT milk;
乳中蛋白酶与UHT乳贮存中的胶凝现象
The gelation time was shortened greatly owing to the catalysis mode of ac.
在不使用任何有机溶剂的条件下,使用氨水调节pH值,正硅酸乙酯-硝酸钾-硝酸铝-水体系在5~12min内即迅速胶凝。
The effects of protein concentration and pH on protein solubility, gel strength, cooking loss and heat-induced gelation properties of porcine leg myofibrils were investigated.
本实验探讨了蛋白浓度和 pH 值对猪腿纤维蛋白的溶解度、凝胶强度、蒸煮失重以及热致胶凝性质的影响。
Effect of pyrolysis atmosphere on properties of BLT ferroelectric films deposited by sol-gel method;
热分解气氛对溶胶-凝胶法制备BLT铁电薄膜性能的影响
Chemistry Mechanism Discussion of Preparing HAP with Sol-gel Method;
溶胶-凝胶法制备羟基磷灰石粉体化学机理分析
Synthesis of the blue long afterglow phosphor Sr_2MgSi_2O_7:Eu,Dy by sol-gel method and its luminescent properties;
溶胶-凝胶法合成蓝色长余辉材料Sr_2MgSi_2O_7:Eu,Dy及其发光特性
The Syntheses of a High Temperature Gellant in Acid Stimulation Using Invert Emulsion Polymerization;
反相乳液法合成高温酸化胶凝剂的研究
Aiming at the special oxidizability of NTO,three different gellants were chosen which could form gel with NTO,and their rheologic properties were studied.
针对四氧化二氮(NTO)的特殊氧化性,筛选了三种不同胶凝剂与NTO形成凝胶,对其流变性能进行研究,并结合发动机试验、限流圈试验、发动机头部液流试验,验证了其与偏二甲肼(UDMH)凝胶组成的双组元推进剂用于凝胶发动机试验的可行性。
This paper presented a survey on the research of the gel propellant H-70, especially the preparation technics, including selection of the gellant and the disperse etc.
文中对肼-70胶体推进剂的国内外研究现状作了概述,着重对其制备工艺进行了具体介绍,包括胶凝剂的选择、分散工艺等方面,并通过实验对比发现对于肼-70体系而言,添加相同含量的B类胶凝剂成胶效果优于A类胶凝剂。
Influence of Decreasing Temperature Rate on Gelling Property of Crude Oil;
降温速率对原油胶凝特性的影响
The gelling property of the cheap gelling material of Xiangxi Gold Mine and its mechanism analysis;
湘西金矿新型廉价胶凝材料的胶凝特性及其机理分析
Studies are also carried out on its chemical stability and the mechanism of gelling property.
对热焖粉化钢渣的材料来源以及工程特性进行了分析 ,并通过非机动车 4号线埋管工程、肇嘉浜路、北虹路排管工程等试验路的实际应用 ,对热焖粉化钢渣作沟槽回填材料进行试验研究 ,并对其化学稳定性和胶凝特性机理进行了探
Titania nanoparticles were then filled into the gaps among the nanorods through an infiltration sol–gel procedure to form a composite titania film with an ordered nanostructure.
用双氧水低温氧化金属钛片的方法制备了TiO2纳米棒阵列,并以该阵列为基体,用浸渍渗透溶胶–凝胶技术制备了TiO2纳米颗粒嵌入TiO2纳米棒阵列基体的复合结构薄膜。
CopyRight © 2020-2024 优校网[www.youxiaow.com]版权所有 All Rights Reserved. ICP备案号:浙ICP备2024058711号