Preparation of high compression strength polyacrylate/polysiloxane interpenetrating network hydrogel;
高压缩强度聚丙烯酸盐/聚硅氧烷互穿网络水凝胶的制备
The compression strength of pitch derived car.
将高温煤沥青和浸渍剂沥青在不同压力下炭化,在2500℃下对所得沥青炭进行石墨化处理;测试了所得沥青炭的体积密度、开孔率;利用扫描电子显微镜(SEM)观察了所得沥青炭的显微结构;利用XRD检测了所得沥青炭石墨化处理后的石墨化度;测试了所得沥青炭的压缩强度。
The structure,thermal stability,especially the effects of isothermal annealing on the microhardness and compression strength of this bulk metallic glass were investigated by X-ray diffraction,differential scanning calorimetry,microhardness and compression tests.
采用X射线衍射(XRD)、示差扫描量热(DSC)、显微硬度及压缩试验等方法研究了非晶合金的结构、热稳定性,特别是等温热处理对其显微硬度与压缩强度的影响。
3D fiber waviness model and prediction of compressive strength of stitched laminates;
缝合复合材料层板三维纤维弯曲模型及压缩强度预报
Computational modified model and experimental verification of compressive strength of the X-cor sandwich
X-cor夹层结构压缩强度模型改进与实验验证
Experimental study on uniaxial compressive strengths of artificial freshwater ice
人工淡水冰单轴压缩强度试验研究
Testing method for compressive(crushing)strength of high performance ceramics
GB/T8489-1987工程陶瓷压缩强度试验方法
Test method for crushing strength of porous ceramic
GB/T1964-1996多孔陶瓷压缩强度试验方法
testing method for compressive strength of hydraulic cement mortars
水凝水泥抗压缩强度测定方法
testing method for compressive strength of fire brick
耐火砖耐压缩强度试验方法
testing method for compressive strength of insulating fire bricks
绝热耐火砖耐压缩强度试验方法
Study on PBO Fiber Compress Strength Modification and Light Aging;
PBO纤维压缩强度改性及其光老化研究
Sintered metal materials--Determination of compression strength at room temperature
GB/T6525-1986烧结金属材料室温压缩强度的测定
paper and board--Compressive strength--Short span test
GB/T2679.10-1993纸和纸板短矩压缩强度的测定法
fine ceramics(advanced ceramics, advanced technical ceramics)-test method for compressive strength of monolithic ceramics at room temperature
细陶瓷-单块陶瓷常温耐压缩强度试验方法
Computational modified model and experimental verification of compressive strength of the X-cor sandwich
X-cor夹层结构压缩强度模型改进与实验验证
NUMERICAL ANALYSIS FOR SIZE EFFECT OF STRATIFIED ROCK MASS UNDER COMPRESSION
层状岩体压缩强度尺寸效应的数值分析
Similarly, adding BGE also conduced to the improvement of impact strength and slight decrease in compressive strength and modulus.
加入BGE后,材料的冲击强度提高,但是压缩强度和模量减小。
Effects of Silicon Carbide on the Cure Depth,Hardness and Compressive Strength of Composite Resin
碳化硅对复合树脂固化深度、硬度和压缩强度的影响
Structural Intensity of Piston Compressor
活塞压缩机结构强度
The Strength Fuzzy Reliability Design of the Helical Compression Spring;
螺旋压缩弹簧强度的模糊可靠度设计
Experimental investigation of compression speed influence on the compressive resistance of electrorheological fluids
压缩速度对电流变液抗压强度影响的实验研究
testing methods for strength properties of adhesives in shear by compression loading
胶粘剂压缩剪切强度试验方法
Preparation of Silicon Rubber with High Strenth and Low Permanent Compressing Disformation;
高强度低压缩永久变形硅橡胶的研制
CopyRight © 2020-2024 优校网[www.youxiaow.com]版权所有 All Rights Reserved. ICP备案号:浙ICP备2024058711号