two -joint inboard slip ddiveshaft是什么意思

网络释义

用法例句

Contact analysis for cardan shaft spline of high speed EMUs;

高速动车组万向节传动轴花键接触分析

two -joint inboard slip drive shaft

两万向节滑动的传动轴

two joint onboard slip drive shaft

两万向节外侧滑动传动轴

Cardan shaft with function of energy saving in coasting

与万向传动轴制成一体的滑行节能装置及控制

flange crossing-transmission shaft universal joint

凸缘叉-传动轴万向节

"When the two shafts are at an angle to each other, the bearings in the yokes permit the yokes to swing around on the trunnions with each revolution."

当两轴相互处在同一角度上,主动轴转动时万向节叉上的轴承使万向节叉绕万向节十字轴摆动。

"The driving shaft causes the spider to rotate, and the other two trunnions of the spider cause the driven shaft to rotate."

主动轴使万向节十字轴转动,另外两个万向节十字头使从动轴转动。

The two-section propeller is supported by a center bearing and coupled together by universal joints.

两段传动轴之间有一个中间支承轴承,并由万向节连接。

Separate the rear universal joint from the transfer case yoke.

从传动箱轴轭上拆下后万向节。

Align mark on the rear link yoke and universal joint to the mark on the transfer case yoke.

将后连接轴轭和万向节上的标志与传动箱轴轭上的标志对准。

plunging constant velocity joint

可轴向移动的球笼式万向节

It is recommended to make marks on the yolks and the cardan shafts so that you can assemble them correctly.

当安装万向传动装置时建议在万向节叉和传动轴上做明显的记号，以便能够正确地安装。

Optimal Design and Kinematical Simulation of the Hooke's Join of Automobile Steering System

汽车转向系统十字轴万向节传动优化设计及运动仿真分析

There must be one or more universal joints to permit variations in the angle of drive. There must also be a slip joint that permits the effective length of the propeller shaft to change.

一个或几个万向节来适应传动角度的变化;一套伸缩花键,能够改变传动轴的现有长度。

Agricultural tractors and machinery-Power take-off drive shafts and position of power-input connection

GB/T17126-1997农业拖拉机和机械动力输出万向节传动轴和动力输入连接装置的位置

Structural Strength Analysis of Constant Velocity Joints for Car Drive-shaft by Finite Element Method;

轿车驱动轴等速万向节结构强度的有限元分析

"The four arms of the spider, known as trunnions, are assembled into bearings in the ends of the two shaft yokes."

万向节十字轴的四个轴颈叫做万向节十字头,分别装在两个万向节叉顶端的轴承中。

Test methods for guards of power take-off drive shafts for agriculture machinery

GB/T5263-1985农业机械万向节传动轴安全防护罩试验方法

The Application of Crown Drop of a Needle Roller with Lundberg s Profile on the Univesal Driveshaft Design;

对数凸度设计在十字万向传动轴中的应用