Research and design of hydraulic buffer with the continual damping orifice;
阻尼孔连续型液压缓冲器研究及设计
e the groove hydraulic buffer,was discussed.
讨论了舰炮的一种反后坐装置 ,即沟槽式液压缓冲器的设计问题 ,通过推导液压阻力公式 ,给出了缩短缓冲引程的有关参数选择及设计方法 ,使后坐行程比原来一段式缩短 2 8%左
The inner flow field of the hydraulic buffer of some machine gun was numerically simulated by using Computational Fluid Dynamics(CFD) software.
以CFD软件为平台,采用动网格模型和非耦合方法,对某重机枪液压缓冲器内部流场进行数值模拟,系统地研究了流场随活塞运动的变化规律和液压阻力特性,将模拟结果与经验公式计算结果和实测数据对比分析,验证了CFD软件在提高武器系统设计和分析精度上的实用性、有效性和先进性。
The overall characteristic formula of hydraulic bumper was gained after analyzing its characteristics,and the speed and pressure difference curve that expressed bumper’s characteristics was gained when relative design parameters were used.
通过分析越野车用液压缓冲器的特性,推导出液压缓冲器的综合特性公式,在代入相应设计参数后,得到了反映缓冲器特性的活塞运动速度和压差关系曲线,然后对液压缓冲器特性的各种影响参数逐一进行了分析讨论。
The architecture-based neural network model of 52SFZ-140-207B type hydraulic bumper was established.
建立了52SFZ-140-270B型液压缓冲器基于结构的神经网络模型。
The structure and dynamic working process of hydraulic bumper were discussed.
分析了液压缓冲器的结构及其动态工作过程 ,介绍了基于结构的神经网络建模方法 。
Simulation analysis of main structure parameters of hydraulic shock absorber based on AMESim;
基于AMESim的液压缓冲器主要结构参数的仿真分析
This paper proposes a mechanical model of hydraulic shock absorber for sled impact test based on the law of orifice flow, and discusses the factors influencing the model.
应用孔口节流理论,建立了汽车模拟碰撞用液压缓冲器的力学模型,同时对主要参数对模型的影响进行了具体的讨论。
Analysis on the dynamic response of hydraulic damper;
冲压设备液压缓冲器动态响应分析
The hydraulic damper proposed can be used in the shock test machine to generate much more violent shock wave.
采用环形缝隙和阻尼孔并联结构的液压缓冲器,利用液体的可压缩性和活塞腔流体出流面积迅速缩小,使活塞腔压力瞬间升高,对被测试件实施冲击。
Parameterized optimization of throttle for gas-hydraulic buffer;
液气缓冲器节流阀的参数优化
About Elevator Study on the Designing Parameters of Hydraulic Buffer;
关于电梯液压缓冲器的设计及参数研究
Simulation Research on Theory of the Passive Hydraulic Buffer and Its Working Process
一种被动式液压缓冲器原理及工作过程仿真研究
The oil buffer with air accumulator is a little size buffer which is designed meeting the demand of( development) of high speed elevator.
带皮囊式蓄能器的油压缓冲器是根据现行高速电梯发展的需要而设计的一种小尺寸液压缓冲器。
hydraulic shock absorber
液压减震器油压缓冲装置
Design of Spacing Hydraulic Bumper for OE Tracking Instrumentation
光电跟踪设备中液压缓冲限位器的设计
working stroke of oil buffer
油压缓冲器工作行程
Study on the establishment of mathematical model on hydraulically buffer structure
液压缓冲机构的缓冲数学模型建立研究
The Research of Pilot-operated Check Valve With Slow Impulse for Hydramatic Supports
液压支架用缓冲式液控单向阀的研究
look aside buffer
后备缓冲器后备缓冲区
accumulator spring
蓄压器弹簧缓冲系统弹簧
Analysis on Dynamic Characteristics of the Hydropneumatic Buffer Based on MATLAB
基于MATLAB的液气缓冲器调车冲击特性分析
The Influence of Oil Viscosity on the Dynamic Characteristics of Hydro-pneumatic Buffer
油液黏度对液气缓冲器特性影响的研究
Drag onto the page. Right-click to make hydraulic or add cushions.
拖到绘图页上。右击可成为液压的或添加缓冲垫。
Design and Application of Hydraulic System for Billet Cushioning Flapper
管坯定尺缓冲挡板液压系统的设计及应用
Oil Buffer Simulation and Testing with Air Accumulator
带皮囊式蓄能器的油压缓冲器仿真与试验
To treat(a solution) with a buffer.
把缓冲液加入(溶液)
THE RESEARCH OF A FULL HYDRAULIC PRESSURE HYDRAULIC IMPACTOR WITH STRIKE ENERGY AND STRIKE FREQUENCY ADJUSTED STEPLESSLY;
全液压独立无级调频调能液压冲击器的研究
Research on Hydraulic Accumulator Absorbing Pressure Pulsation in the AGC Hydraulic System
蓄能器在AGC液压系统中吸收液压冲击的研究
CopyRight © 2020-2024 优校网[www.youxiaow.com]版权所有 All Rights Reserved. ICP备案号:浙ICP备2024058711号