To Readjust- Loosen lock nut on the adjusting screw.
重新调节:松开调节螺丝上的锁定螺母。
Tighten the pressure regulator.
请拧紧压脚调节螺丝。
To replace seat/ stem module shut off supply, loosen locknut and back off adjusting screw.
要更换阀座/杆模块,先关闭供应管道,松开锁紧螺母,退出调节螺丝。
After the amount of oil in the hook has been properly adjusted with the oil amount adjustment screw, make the sewing machine run idle for approximately 30 seconds,
用油量调节螺丝调整之后,请进行30秒左右的空运转,
Remove compression from spring by turning adjusting screw (1) counterclockwise.
通过反时针方向旋转调节螺丝(1)从弹簧上拆卸压缩件。
feed regulator thumb screw
进料调节器指拧螺丝
Move the feed dog up or down to perform adjustment, then securely tighten the screw.
上下移动送布牙调节高度,然后拧紧紧固螺丝。
Mount restrictor bar into the restrictor bar groove of upper die, mount adjusting bolt for restrictor bar into the bolt hole in the restrictor bar, then mount lower press block, upper press block.
在上模节流棒槽内装入节流棒,将节流棒调节螺栓装配进节流棒的螺丝孔中,再装配上压块。
ratchet wrench extension
手摇螺丝扳手接长节
All floor-mounted cabinets are supported on four leveling screws that are adjustable from access in toe base.
所有地面安装式柜体均由4个可调螺丝支撑,由踢脚板开口处调整螺母以调节台面水平。
Using a screwdriver to adjust the thermostat pointer, set the thermostat( s) to the desired water temperature.
使用螺丝刀调节温控器上的指示器,设置所需要的水温。
Unscrew body halves using open end or adjustable wrench on flats provided.
采用预备好的平头上开口或可调节扳手拧下一半阀体上的螺丝。
engine idling speed adjusting screw
发动机怠速调整螺丝
Idle-mixture screw
慢车混合比调整螺丝
If adjustment is required, turn adjustment control with screwdriver in either direction slowly until vibration or hum stops.
如果需要调节,则用螺丝刀从两个方向慢慢旋转调节控制,直到振动或蜂鸣声停止。
"Bolts,screws & nuts"
"螺栓,螺丝及螺帽"
steering arm adjusting screw wrench
转向臂调节螺钉扳手
brake thrust screw
制动器止推调节螺钉
CopyRight © 2020-2024 优校网[www.youxiaow.com]版权所有 All Rights Reserved. ICP备案号:浙ICP备2024058711号