finger contact是什么意思

网络释义

用法例句

Analysis on contact deformation and stress for rubber O-sealing ring;

橡胶O形密封圈的接触变形及应力分析

Calculation of contact deformation with relative sliding;

具有相对滑动的接触变形计算

The elastic impact procedure of a beam under lateral impact of ball was simulated by using numerical method in which the contact deformation was considered.

使用数值方法模拟考虑接触变形的梁受到球横向弹性碰撞的全过程。

The fractal contact model was used to calculate the additional friction coefficient caused by water film meniscus.

采用分形接触模型推导并计算了由水膜的弯月面效应引起的附加静摩擦力,得到了由水膜的弯月面效应引起的附加静摩擦力的表达式,表明随着分形维数D的增大和分形粗糙度G的减小,计算的附加静摩擦系数增大,同时随着相对湿度的增加,水膜厚度增加,附加的静摩擦系数增加。

The fractal contact model was used to calcu.

利用分形接触模型推导并计算了由水膜的弯月面效应引起的附加静摩擦系数 ,计算结果与实际变化趋势相吻合 ,静摩擦系数的计算值比实际值稍偏大 。

Calculation of actual contact angle during elastic contact deformation between recirculating ball screw and nuts

滚珠丝杠副产生弹性接触变形时实际接触角的计算

THE EFFECTS OF CONTACT DEFORMATION OF LINE-CONTACT CATT CYLINDER GEAR ON THE BENDING STRESS IN THE FILLETS

线接触圆弧齿线圆柱齿轮齿面接触变形对齿根应力的影响

Adhesive elastic interaction of micro punch pre-contact

微冲头的微观粘附力及预接触变形分析

An Analytical Method for Calculating of Hollow Cylindrical Roller Contact Deformation

空心圆柱滚子接触变形的一种计算方法

Influences of bar/specimen contact surfaces' indentation on strain measurement in SHPB experiments

压杆/试样表面接触变形对SHPB实验应变测量的影响

An Investigation on Material Micro-removal in Ultrasonic Gear Honing and Contact Analysis;

超声波平行轴硬珩齿微观切削过程的研究及其接触变形分析

Comparison of Simulation Results of Local Contact Deformable Models on Multiple Elastic-plastic Impacts of Simply Supported Beam

局部接触变形模型对简支梁多次弹塑性撞击模拟结果的比较

Studies on Deformation of Non-Contacting Gas-Lubricated Face Seal;

非接触式气体润滑机械密封变形研究

Base on the elasticity contact and deformation theory, study the contact load and deformation of the pin and the link chain.

运用弹性接触和变形协调理论,研究销与接链环的接触受力及其形变。

APPLYING VCL BACK-UP ROLL TORAISE THE CONTROL LEVEL OF STRIP SHAPE

应用变接触长度支承辊提高板形综合调控能力

Axial load-deformation curve and preload on angular con act ball bearings

角接触球轴承的轴向载荷—变形曲线和预紧

Study on Tool and Chip Contact Area DeformationTest for Martensite Ageing Steel Cutting

马氏体时效钢的刀-屑接触区变形试验研究

Study on the change of the pattern visual evoked potential in work-ers exposed to lead

铅接触工人图形视诱发电位改变的研究

A Contact Detection Method for the Three-dimensional Blocky System and Discontinuous Deformation Analysis (DDA);

三维块体系统接触检索算法与非连续变形分析

NON-CONTACT MEASUREMENT TECHNIQUE FOR DYNAMIC RADIAL DEFORMATION OF EXPLOSION CONTAINMENT VESSELS

爆炸容器动态径向变形非接触测量技术

Study on Shape Control Characteristics for Varying Contact Intermediate Roll of 6-hi Cold Rolling Mill

六辊冷轧机变接触中间辊板形控制性能研究

Additionally, the stressand displacement of contact element are analysed, and the contact condition between“soft adapter” and rockfill dam are studied.

另外,还分析了接触单元的受力、变形情况,研究“软接头”与堆石坝之间的接触情况。

The grain refinement begins from the center ellipsoidal zone, and then gradually expands to the vertical edge zone and conical contact zone.

细化首先开始于易变形区,再相继扩展到纵向棱边区和接触锥形区。