Friction-typed high-strength bolt connection是什么意思

网络释义

用法例句

In this paper,the feasibility and rationality of a rigid flange connection with friction type connection of high-strength bolt is proved with analyzing and scale model test.

采用高强螺栓摩擦型连接的法兰来保证河南省广播电视发射塔外塔柱承载力和抗弯刚度的连续性,并通过构件的缩尺加载试验进行验证,说明了该拼接节点的合理性和施工的可行性。

In order to research the damage evolution rules of three typical details of bolt and weld steel bridges(lap joints,non-load-bearing fillet weld joints and high-strength bolted friction-type joints),the relations between damage degree and cycle ratio of the three details were investigated by MTS(mechanical testing and simulation)fatigue testing machines with sinusoidal loadings.

为了研究搭接节点、不承载角焊缝节点、摩擦型高强螺栓连接节点这3种典型栓焊钢桥细节的疲劳损伤演化规律,采用MTS疲劳试验机和正弦波加载的方法研究了这3种细节的损伤程度与循环比之间的关系,共进行了4个单面盖板搭接节点、2个不承载角焊缝节点和2个摩擦型高强螺栓连接节点的疲劳试验,建立了这3种典型细节基于Chaboche疲劳损伤模型的损伤演化方程:单面盖板搭接节点细节:D=1-[1-(n/Nf)0。

In order to make sure that the design calculation of friction_type high_strength bolt connection is more reasonable, a method of assessing the reliability of friction-type high strength bolt connection when achieving the maximum design allowable bearing power by analyzing many main factors and with a lot of experiments data of friction-type high strength bolts.

为使摩擦型高强度螺栓连接设计计算更趋合理,结合大量有关摩擦型高强度螺栓的试验资料,通过对影响高强度螺栓连接承载能力的多种主要随机因素的分析,利用一次二阶矩实用概率理论,给出了一种当高强度螺栓连接达到最大设计容许承载力时的可靠度的评估方法,并结合具体算例验证了该方法的可行性。

EXPERIMENTAL STUDY ON ANTI-SLIDING COEFFICIENT OF FRICTION TYPE HIGH-STRENGTH BOLT CONNECTORS

摩擦型高强度螺栓连接件抗滑移系数试验研究

Treatment method of the high strength bolt friction type connection interface

高强度螺栓摩擦型连接接触面的处理方法

Sets of torshear type high strength bolt hexagon nut and plain washer for steel structures

GB/T3632-1995钢结构用扭剪型高强度螺栓连接副

Technical requirement for sets of torshear type high strength bolt hexagon nut and plain washer for steel structures

GB/T3633-1995钢结构用扭剪型高强度螺栓连接副技术条件

Study on the Behavior and Design of High-strength Bolted Endplate Connections in Light-steel Gabled Frames;

轻型门式钢架结构高强度螺栓端板连接承载性能研究

Mechanical Behavior Research for High Strength Bolt Connection Joint of Main and Secondary Beam

主次梁承压型高强度螺栓连接节点受力性能研究

Finite Element Analysis for Mechanical Property of High-strength Bolt Connection in High Temperature;

高强度螺栓连接高温力学性能有限元分析

Code for design,construction and acceptance of high strength bolt connection of steel structures

钢结构高强度螺栓连接设计施工及验收规范

The Finite Element Method and Experimental Analysis of High Strength Bolted Connections;

高强度螺栓抗拉连接的仿真及实验研究

High strength joint bolts and nuts for rails

GB/T5098-1985钢轨用高强度接头螺栓、螺母

Research on Ultimate Capacity of High-strength Bolt Connection of Steel Structure at High-temperature;

高温下钢结构高强度螺栓连接极限承载力的研究

Experimental Study of the Behavior of the High-strength Bolted Connections in High-temperature;

高强度螺栓连接在高温环境下受力性能的试验研究

Behavior of High-strength Bolted Endplate Connection Steel Structure under Monotonic and Cyclic Loading;

静力、循环荷载下高强度螺栓端板连接节点的性能研究

Refined 3D Finite Element Modeling and Analysis of Steel Frame with High-strength Bolted Endplate Connection;

高强度螺栓延伸端板连接钢框架有限元整体分析及研究

Special Anti-rust Coating Inorganic Zinc-rich Connections in the Application of High Strength Bolts

特制无机富锌防锈防滑涂料在高强度螺栓连接中的应用

The Research for the High and Strong Stud Bolt Joint of Steel Beam and Concrete Wall with Inside Covering up Profiled Bar

钢梁与内埋型钢混凝土墙高强螺栓连接节点的研究

Reason for Low Tight Axle Strength of 10.9S Sets of Torshear Type High Strength Bolt for Steel Structures

钢结构用10.9S扭剪型高强螺栓连接副紧固轴力偏低原因分析

3D Nonlinear FE Analysis on T-Stub Steel Connection

高强螺栓T型钢连接节点三维非线性有限元分析