level shoe是什么意思

网络释义

用法例句

The influence of leveling staff error on the data of vertical crust deformation is discussed.

讨论水准标尺误差在垂直形变资料中的影响。

The paper introduces a method to obtain the edge in the grade rod image processing and the test case in the experiments.

介绍了在采用图像法对水准尺进行检测过程中水准尺边缘获取的方法及实验验证的情况,在对图像法检测中存在的问题进行分析的基础上,提出了一种光电技术、信号处理技术以及单片机控制技术相结合的实用解决方案。

Based on the analysis of the influence of the oblique leveling staff on the height difference, some measures about how to decrease the effect of the oblique leveling staff on the subsidence deformation are put forward,and the correct account of formulae is given.

在分析了水准尺倾斜对高差影响的基础上 ,提出了减弱水准尺倾斜对沉降变形量影响的具体措施及改正计算公式 ,结合武汉市鑫汉花园的沉降监测的工程实践 ,对其影响作了分析 ,得出了一些有用的结论和建议。

Geodetic leveling should be done with staves in which the divisions are marked on a strip of invar.

大地水准测量必须使用刻度标于不胀钢片上的水准标尺。

The influence of leveling staff error on the data of vertical crust deformation is discussed.

讨论水准标尺误差在垂直形变资料中的影响。

Geodetic levelling should be done with staves in which the divisions are marked on a strip of invar.

大地水准测量必须使用分划刻在因瓦带上的水准标尺。

The Compensation for Abbe Error in the Leveling Rod Tests Systems Useing Laser Interferometer

双频激光干涉仪用于水准标尺检测中的阿贝误差补偿

The movable target on a leveling rod.

视准器水准尺上可移动的目标

Standard linear dimensions

GB/T2822-1981标准尺寸

This national standard specifies the dimensions of ......

本国家标准规定……的尺寸

forty foot equivalent unit

40英尺标准集装箱

scfh (standard cubic foot per hour)

标准立方英尺/小时

Scfm (standard cubic foot per minute)

标准立方英尺/分钟

standard size of roll for mixing mill

混砂机棍的标准尺寸

out of gauge bit

尺寸不合标准的钻头

Standard for dimensions of kitchen fixtures in residences

住宅厨房设施尺度标准

standard sizes of paper, units of weight, etc

纸的标准尺寸、 标准重量单位.

A standard dimension, quantity, or capacity.

尺度，标准标准的体积、数量或容积

Checking Acceptance Specification of Geometric Shape and Dimension of Prototype Turbine Runner

原型水轮机转轮几何形状及尺寸的检测标准及验收

Natural gas hydrate contains 150-200m^3 of gas per m^3 solid hydrate.

在标准状况下1立方公尺的气体水合物可储存150~200立方公尺的天然气。

Discuss About Dimensions of AutoCAD;

AUTOCAD中标准尺寸的标注方法