Research on interlocking communication protocol conversion of radio based cab signal for Qinghai-Tibet Railway;
青藏铁路无线机车信号联锁通信协议转换的研究
Research of Key Techniques for Industrial Protocol Conversion Gateway;
工控网络协议转换网关关键技术的研究
Research of PROFIBUS DP and CAN Protocol Conversion and the Gateway Development;
PRCFIBUS DP与CAN协议转换研究及其网关开发
The development of DeviceNet bus serial protocol converter based on DSP;
基于DSP的DeviceNet串行协议转换器的软硬件设计
Design and implementation of protocol converter of Harris SPC exchange
Harris交换机协议转换设计与实现
It discussed the interconnection between family network and intelligent Res-idential through Protocol converter.
针对我国实际情况提出了将贵州以太公司推出的家庭网络和目前在楼宇中应用广泛的Lonworks总线网络相结合,讨论了通过协议转换器实现家庭网络和智能小区的互联。
Design and implementation of security gateway prototype system based on protocol translation;
基于协议转换的安全网关原型系统设计与实现
It includes three function modes as follows: translation of IPv4 and IPv6 addresses,IPv4 and IPv6 protocol translation,and the application layer gateway.
该技术包括3个功能模块:IPv4到IPv6地址绑定、IPv4与IPv6协议转换和应用层协议转换;转换网关是在Linux平台的Netfilter过滤框架相关钩子点挂载转换网关功能模块实现的。
Three mechanisms were analyzed in this article: Dual IP Stack, Tunneling and NAT-PT(Network Address Translation-Protocol Translation).
本文分析了从IPv4到IPv6过渡的三种常用机制:双协议栈技术、隧道技术和NAT-PT(网络地址-协议转换)技术,建立一个小型、简易的实验室,具体给出了NAT-PT的实现技术方法和步骤,最后通过NAT-PT网关的地址和协议转换功能成功将IPv6和IPv4数据包相互转换。
In this paper, protocol transform was put forward, and its potential limitations were analyzed.
提出了协议转变的概念,分析这种转变潜在的缺陷;在此基础上,着重阐述如何通过这种协议转换进行拒绝服务攻击,分析这种拒绝服务攻击手段的特点。
This paper analyzing the function and connecting method of the protocol transformer firstly,and then introduces the design of the hardware system and the implementation of driver program of the RTL8019AS and the application program.
文章首先分析了协议转换器的功能、连接方式,然后介绍了硬件系统的设计、RTL8019AS驱动程序和应用程序的实现。
We describe the data style, design and realize an efficient data collection and protocol transform system.
分析了马可尼SDH网管系统的通信协议与告警数据格式,设计并实现了一个高效的告警采集与协议转换系统,采用了优化的数据处理技术,用于判断实时告警数据属性,确认是新增告警、已采集告警、还是恢复告警,把新增告警和恢复告警以SNMP包Trap格式向上发送。
The WorldFIP-RS485 Protocol Transformer;
WorldFIP-RS485协议转换器
Design and implementation of protocol converter of Harris SPC exchange
Harris交换机协议转换设计与实现
Research on the Transformation between WSP and HTTP Based on the Message Type;
基于报文类型的WSP协议和HTTP协议转换研究
Research about Implementation of IPv4/IPv6 NAT-PT;
IPv4/IPv6地址协议转换实现研究
Research of PROFIBUS DP and CAN Protocol Conversion and the Gateway Development;
PRCFIBUS DP与CAN协议转换研究及其网关开发
A Development and Approach of PROFIBUS-DP and HART Protocol Conversion;
一种PROFIBUS-DP与HART协议转换的实现
Research of CAN/LIN Protocol Converting Gateway Based on FPGA;
基于FPGA的CAN/LIN协议转换网关的研究
The Hardware Designing of Protocol Conversion Based on DS80C320;
基于DS80C320的协议转换器硬件设计
Research on Technology of Communication Protocol Conversion for Devices in Gas Stations
加油站设备通信协议转换技术的研究
Design of DeviceNET Fieldbus and RS-485 Protocol Conversion Module
DeviceNET与RS-485协议转换模块的设计
Design of Protocol Converter Based on BACnet and Modbus
基于BACnet和Modbus协议转换器的设计
FPGA-based Study Protocol Conversion CAN_USB
基于FPGA的CAN_USB协议转换的研究
Design and Implementation of Protocol Transformer Based on S3C44B0X
基于S3C44B0X的协议转换器的设计与实现
Design of RS485-Ethernet Converter Based on LM3S8962
基于LM3S8962的RS485-Ethernet协议转换器的设计
Development and Application of EtherNet-Modbus Protocol Conversion Module
以太网-Modbus协议转换模块的开发及应用
Research and Realization of Universal Communication Protocol Conversion Interface
通用通信协议转换接口的研究与实现
Design and Implementation of Converter for TS and Multi-channel E1
TS流与多路E1协议转换器设计与实现
Design and Implementation of NAT-PT Protocol Translation Gateway
NAT-PT协议转换网关的设计与实现
CopyRight © 2020-2024 优校网[www.youxiaow.com]版权所有 All Rights Reserved. ICP备案号:浙ICP备2024058711号