bearing carrier是什么意思

网络释义

用法例句

Basing on the test of the hydraulic parameters of bearing prong in type 150JD56 long-axial pump, this research determined a plural retrogression formula on local resistance coefficient of bearing prong when a long-axial pump runs at the highest efficiency, and introduced the methods and steps in experiment, providing scientific foundation for the reasonable corollary of aqueduct in l.

轴承支架是长轴深井泵(长轴泵)输水管路的重要组成部分,其水头损失的大小直接影响管路效率的高低。

Discussion on the Hydraulic Parameters of Bearing Prong in Long-axial Pump for Deep Well;

长轴深井泵轴承支架水力参数的探讨

Mode and Finite Element Analysis of the Centrifugal Pump Bearing Bracket;

离心泵轴承支架的模态及有限元分析

The carriage is supported on guide shafts.

托架支承在导轴上。

cageless bearing

无保持架轴承,开口轴承

pto bearing support

动力输出轴支持轴承

Remove thrust bearings from rear main bearing carrier.

从后主轴承托架上拆下止推轴承。

The susceptor rested on a pedestal whose shaft is connected to a motor that provides rotation.

感应器安装在轴承台上，它的支架与提供旋转的马达相接。

Modeling for Rotor System of AC Magnetic Bearing Electric Spindle;

交流磁轴承支承电主轴转子系统建模

Most Bearings support rotating shafts against either transverse (radial) or thrust (axial) loads.

大多数轴承都支承径向或轴向负荷的转轴。

Excessive friction in strut upper bearing

支柱上轴承磨损过度

In order to represent this behaviour, we can consider one of the supports to be a pin support and all the others to be roller supports.

为阐明这一特点，设梁的支承之一为销轴支承，其他均为辊轴支承。

rubber vibration isolators for journal bearing thrust bearers of railway rolling stock

铁路车辆车轴轴承推力支承用振动隔绝橡胶

Optimization Design of Active Magnetic Bearing Stiffness Based on ANSYS

基于ANSYS的电磁轴承支承刚度优化

load support and pusher

货物支承架和推出器

quadruped-frame supported vent stack

四腿钢架支承的排气筒

tripod-frame supported vent stack

三腿钢架支承的排气筒

The top end bracket shall be fitted with a stainless steel lifting bail and shall be capable of supporting the combined weight of the pump and motor.

顶部尾轴承架应该配置不锈钢吊环，应该能够支撑泵和电机的总重量的压力。

The top end bracket shall be fitted with a lifting bail and shall be capable of supporting four (4) times the combined weight of the pump and motor.

顶部尾轴承架应该配置吊环，应该能够支撑泵和电机的总重量四（4）倍的压力。