steer axle spindle是什么意思

网络释义

用法例句

steering knuckle bearing grease nipple

润滑转向节轴承油嘴

Research and Development of a Real-Time Quality Monitoring System for Assembling Steering Knuckle Bearing

转向节轴承装配质量实时监控系统的研究与开发

Steering Knuckle Separation From Driveshaft

转向关节与驱动轴分离

"The driving shaft causes the spider to rotate, and the other two trunnions of the spider cause the driven shaft to rotate."

主动轴使万向节十字轴转动,另外两个万向节十字头使从动轴转动。

"When the two shafts are at an angle to each other, the bearings in the yokes permit the yokes to swing around on the trunnions with each revolution."

当两轴相互处在同一角度上,主动轴转动时万向节叉上的轴承使万向节叉绕万向节十字轴摆动。

The steering wheel is mounted on a steering shaft that extends into the steering gear.

转向盘安装在转向轴上,转向轴延伸至转向器。

"The steering-knuckle arm, attached to the front wheels, are therefore forced to swing the wheels to the right or left on their pivots."

于是,与前轮相连的转向节臂使车轮在其轴线上左右转动。

Optimal Design and Kinematical Simulation of the Hooke's Join of Automobile Steering System

汽车转向系统十字轴万向节传动优化设计及运动仿真分析

counter crankshaft rotation

反曲轴转动方向的转动

"In order to permit the front wheels to swing to one side or the other for steering, each wheel is supported on a spindle which is part of a steering knuckle."

为了使前轮能够在转向时向一侧或向另一侧摆动,每一个车轮由转向节上的主轴来支撑。

coupling for the transmission of rotary motion

传递回转运动联轴节

During steering maneuvers, the strut and the steering knuckle (through the ball joint and a pivot bearing in the strut's upper retainer) turn as an assembly.

车辆转向时，支柱以及转向关节（经由球形接头与上支柱固定器之轮毂轴承）会一体旋转。

two -joint inboard slip drive shaft

两万向节滑动的传动轴

flange crossing-transmission shaft universal joint

凸缘叉-传动轴万向节

The Tibial Longitudinal Rotation during Flexion after Medial Unicondylar Arthroplasty;

人工内侧单髁置换对膝关节伸屈过程中胫骨轴向旋转的影响

Most Bearings support rotating shafts against either transverse (radial) or thrust (axial) loads.

大多数轴承都支承径向或轴向负荷的转轴。

The hub and bearing assembly does not require removal from the steering knuckle to replace wheel attaching studs in the hub and bearing assembly.

更换轮毂及轴承组件内的车轮固定螺桩无需自转向关节中取出轮毂及轴承组件。

side bearing arch

中摇枕(三轴转向架)