According to the operating logics of 110 kV automatic stand-by power switching devices,this paper analyzes the problems as to the introduction of the breaker condition contact and the cooperation with the security and stability system.
根据备用电源自动投入装置的动作逻辑,对110kV备用电源自动投入装置开关位置接点的引入问题和与安全稳定系统的配合问题进行分析,并结合电网的实际情况,探讨具体的解决方案,目的是进一步提高110kV备用电源自动投入装置动作的准确性。
Drain Plug/Backup Light Switch Location
放油塞/倒车灯开关位置
a switch in the up position.
位于上升位置的开关
DISCONNECT THE PARK NEUTRAL SWITCH.
断开停车空档位置开关。**
holding position
(继电器 的)吸持位置;自保位置;保持(开或关的)位置
TRACTION CONTROL SWITCH (TC) LOCATION
牵引控制开关(TC)位置
Three-position switch (120 deg. step). Contact positions can be specified.
位置开关(120 度间距)。可指定触点位置。
TURN IGNITION FROM THE OFF POSITION TO THE ON (RUN) POSITION.
把点火开关由关闭位置转到打开(运行)位置。
Park/Neutral Position Switch and PRNDL Switch
停车/空档位置开关及PRNDL开关
Be sure to turn off the switch before recharging.
务必在充电前将电源开关置于OFF位置
Make sure switch is OFF before turning on power.
接通电源前,应确保开关处于断开位置。
To release from a closed or fastened position.
打开从关闭的或固定的位置上移开
Initial Position Estimation of Sensorless Switched Reluctance Motor
无位置传感器开关磁阻电机初始位置检测方法
T3Manual Valve Lever Position Switch C3 Sense or Park/Neutral Position Switch Sense circuit.
**T3=手工阀门操纵杆位置开关C3感知或停车/空档位置开关感知电路
PRESS THE DOOR LOCK SWITCH TO THE LOCK POSITION.
把门锁开关压到锁的位置。
Set the TAPE/OSC switch to the correct position.
将TAPE/OSC开关设定于正确的位置
TRS connector or P/N position switch connector
TRS接头或P/N位置开关接头
NOTE: THIS IS NOT THE PARK NEUTRAL POSITION SWITCH.
注意:这不是停空档位置开关。
TRANSMISSION SWITCH AND PLUG LOCATIONS
变速箱开关与注油塞位置
CopyRight © 2020-2024 优校网[www.youxiaow.com]版权所有 All Rights Reserved. ICP备案号:浙ICP备2024058711号