Top pouring是什么意思

网络释义

用法例句

Concrete pouring technology of steel-pipe arch rib of concrete arch bridge;

钢管混凝土拱桥拱肋混凝土顶升灌注工艺

This construction procedure was finished with once pumping, jacking and pressed pouring under the situation of high temperature, long distance transportation and high technical difficulty.

介绍了在高温、混凝土运距远、技术难度高的情况下 ,一次性泵送顶升压注完成了武汉江汉五桥 2 40m跨的拱桥钢管混凝土的施工过程 ,测定了在密封条件下混凝土的早期膨胀率和强度的发展规律 ,详细记录了泵送压力的变化过程。

Development Automatic Control System for Distillation Tower Overhead Ammonia Injection and pH Value

蒸馏塔顶注氨及pH值自动控制系统的研制

The emperor gazed at the snowy peak of the mountain.

皇帝注视着积雪的山顶。

Did you notice the hat she was wearing?

你注意到她戴的那顶帽子吗？

Also note that( View x Projection) matrix is per scene, not per vertex.

请注意矩阵是个别场景，不一个顶点。

The rotor cataracts water over the top of the machines.

回转轮将水从机器顶上注入。

When he came to the top of the hill, he looked down into the valley of shadows below.

他来到山顶时，往下注视着阴暗的山谷。

Now Peter's attention was diverted to the roof-edge.

现在彼得的注意力又转到屋顶边上。

Theory and Application on Top-Coal Caving Characteristics and Water Pre-Infusion to Treat Top-Coal;

顶煤冒放特性与预注水处理顶煤的理论研究及其应用

The man looked at the tall grass that grew on the roof of his house.

那人注视着长在他房子屋顶上的高大青草。

The ceiling of the President's bedroom will be designed for two intravenous hookups.

总统卧室的顶部有两个静脉注射器挂钩；

He watched the coffee beating in the cracked dome of the percolator.

他注视着咖啡壶破裂的圆顶内翻腾的咖啡。

He had observed all around him how blond men went bald first.

他注意到周围人中金发男子总是秃顶秃的早。

Parietal Lobe Damage, Visual Neglect, and Cognitive Neuroscience of Visual Attention

顶叶损伤、视觉忽视与注意的认知神经科学

Open test cock3 and allow water to fill the tube to the top.

开启测试旋塞3号，使得水注到管子的顶部。

NOTE: ENSURE THE DOME LAMP SWITCH IS IN THE MIDDLE POSITION BEFORE PROCEEDING

注意：在进行前，确保圆顶灯开关是在中间位置

Mrs. Duncan tried to make herself conspicuous by wearing a new hat.

邓肯夫人戴了顶新帽子，想突出自己，引人注意。

He had noticed, at the top of the Pyramid of the Inscriptions, a stone slab with holes in it.

他注意到在铭文金字塔顶部有一块带孔的石板。

Development for CAD System of Ejection Mechanism of Injection Mould Based on AutoCAD;

基于AutoCAD的注塑模顶出机构CAD系统的开发